Can I stop on roads?

Heavy vehicles (weighing 4.5 tonnes or older) or long vehicles (measuring 7.5 metres or longer) may possibly stop within a built-up area for approximately one hour, unless otherwise signed. To discuss anything not covered we recommend call the DVLA phone number.

Parking issues generally fall inside responsibility of local governments. A local government can make a local law with this issue that can prevail within the state law. However, your regional law must stay consistent with state regulations.

Section 200 with the Queensland Road Rules applies.

What would be the minimum following distance?

The Department of Transport and Main Roads recommends which you drive keeping the absolute minimum two second gap between vehicle along with the vehicle right in front (following distance). The two second measure is when ever driving conditions are ideal. In adverse conditions, double the amount following distance to four seconds.

Heavy vehicle drivers should have a three to four second following distance between their vehicle along with the vehicle in the front.

Long vehicles (measuring 7.5 metres or longer) must keep the very least distance of 60 metres behind another long vehicle unless:

driving on the multi-lane road
driving in the built-up area
overtaking
driving inside a road train area (the location where the minimum distance is 200 metres).

Sections 126 and 127 in the Queensland Road Rules apply.

What should I do at load limit signs?

An image of a road sign showing a bridge load limit.You must not drive past a bridge load limit sign, or possibly a gross mass limit sign, in the event the gross mass in the vehicle is in excess of that stated around the sign. This usually pertains to heavy and long vehicles.

Section 103 in the Queensland Road Rules applies.

When must I use low gear?

An image of a road sign saying: Trucks and buses must use low gear.On steep routes, the location where the sign indicates, trucks and buses must drive inside a gear that is certainly low enough to limit the speed from the vehicle without relying about the primary brake.

This sign is employed in areas for example Cunningham’s Gap along with the Toowoomba range.

The rule is made to reduce the incidence of brake fade in heavy vehicles thereby decreasing the potential for serious accidents.

Section 108 from the Queensland Road Rules applies.